RED statormatic starters offer an unrivalled starting capability and have the following advantages:
The starters of this range can be supplied in three formats: RC, RW or RZ. They are made up of two parts:
The decrease in resistance of an electrolyte when heated is used inside an electrode chamber. The resistance is connected in series with the motor windings to reduce terminal volts, starting torque and current drawn from the line.
As the motor runs up to speed, there is an automatic decrease in resistance value with a consequent increase in motor voltage, giving smooth acceleration without torque or current peaks.
At the end of the run-up period a timed contactor closes and short circuits the residual resistance.
Reduction of the starting torque is determined according to the requirements of the driven machine or the current limitation.
|Reference||Protection||Number of electrode assemblies||Rating||Short circuit contactor (choice)|
|RC2P/3||IP31||3||30 kW (40 ch.) max||25 A
|RC2E/3||IP52||3||30 kW (40 ch.) max|
|IP31||3||75 kW (100 ch.) max||25 A
|IP31||6||150 kW (200 ch.) max|
|IP31||9||225 kW (300 ch.) max|
|IP52||3||75 kW (100 ch.) max|
|IP52||6||150 kW (200 ch.) max|
|IP52||9||225 kW (300 ch.) max|
|RZ2/3||IP11||3||30 kW (40 ch.) max|
|RZ5/3||IP11||3||75 kW (100 ch.) max|
|RZ5/6||IP11||6||150 kW (200 ch.) max|
|RZ5/9||IP11||9||225 kW (300 ch.) max|
|RZ5/12||IP11||12||300 kW (400 ch.) max|
|RZ5/15||IP11||15||750 kW (1000 ch.) max|
Voltage between phases: 690 V
* In case the starter is made of more than one enclosure, only one has a thermostat.
The RC or RW enclosure consists of the starting electrolytic resistance and the short-circuit start and run contactor with relay timer.
The resistance frame RZ consists of the resistance only with a thermostat*, and can be delivered with separate waterproof enclosure WS for chemical industries and for marine environments (see below).
The WS3 enclosure has been designed to accept equipment which cannot be mounted in RC and RW enclosures and when the starter is supplied with RZ type resistance frames.
|Electrolyte||Composition : In powder or crystal form for mixing with drinking water and anti-evaporation oil
Electrolyte temperature is controlled by thermostat 16 A/400 V.
Electrolyte level: level is visible through transparency of tanks.
|Electrode assembly||The RED “monophase” electrode assembly is a standard component.
The value of resistance is factory preset according to the data of the driven machine given by the customer at the order. It is always possible for him to make adjustments on site, either for a change of drive of for a different duty. This is easily carried out by changing the electrolyte and/or the size of the electrode chamber.
|Antigel (option)||Protection down to – 20°C
It has to be inserted into the electrolyte before commissioning since it alters its resistivity. Il can be used throughout the year.